![]() ![]() iwlwifi 0000:01:00.0: Direct firmware load for iwlwifi-8265-25.ucode failed with error -2 iwlist wlan0 scanningīit Rates:1 Mb/s 2 Mb/s 5.5 Mb/s 11 Mb/s 18 Mb/sīit Rates:6 Mb/s 9 Mb/s 12 Mb/s 48 Mb/s ‘Signal level=-27 dBm’ a good quality for the signal with channel 10. Just give some information hope could help. ![]() TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0īecause I don’t have a Edimax EW-7811UN Wifi adapter on my hand. The Dropped packets and errors number should also give you some useful information. In the same time check the kernel logs from the dmesg command, if there is a disconnection there must be some information there indicating if it’s an error or just lost the signals. If the Signal level is weak it will disconnect from the AP port. So both usb and signal/channel will give some abnormal behavior. For USB WIFI, it first go through the USB interface, then transfer data via the air. You can monitor the ‘Signal level’ and the channel your USB WIFI working with. ![]() This is the log I have catched from Intel 8265 NGW. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |